J-PAC-C (Control Only Version)

Ultimarc

  • $89.95
  • Save $20


Connect a PC to a JAMMA cabinet in seconds!


The J-PAC (JAMMA interface for Pc to Arcade Controls) is a board which allows plug-in connection of a JAMMA arcade cabinet to a VGA card and keyboard port or USB port on a PC motherboard. It incorporates all the advanced features of the I-PAC with an on-board JAMMA connector

  • Has inputs fully protected against static discharge and reverse connection, now supports 3 extra JAMMA connections (Tilt, Service SW and Test)
  • Now supports 12 volt coin doors.
  • Fully programmable key code set. Stored even after power off.
  • Dual interface USB or Keyboard.
  • Supports I-PAC optional pre-assembled LED harness with 3 panel mounting LEDs which emulate the keyboard Lights.
  • Lead plugs into USB port.
  • Self-Test LED gives an instant check of all your wiring. Can indicate which, if any, input has a problem.
  • No separate power needed.
  • Does not use a matrix - no ghost keys. All inputs are completely separate and generate their own interrupt - this is the fastest possible method.
  • Does not use a scanning method which causes a variable delay.
  • Either uses standard MAME keys or you can program your own character set.
  • Shift functions. Holding "Start1" and pressing other buttons sends a range of codes for MAME functions such as "escape", "Coin 1", "tab", "enter". This means no extra buttons are needed on the cabinet. In programmable mode any input can be the shift key and all keys can be programmed with a shifted code.
  • No special drivers needed. USB drivers are generic Windows.
  • All control inputs which are part of a normal JAMMA standard are routed to an on-board JAMMA edge connector.

    Comparison of J-PAC Control-only version with standard J-PAC
J-PAC J-PAC Control-Only
Video Passthrough with frequency blocking YES NO
VGA Cable Supplied YES NO
Number of buttons per player 8 6
Buttons 5 and 6 Support Screw Terminals JAMMA Connector (newer cabinets usually are wired this way)
Speaker Support Screw Terminals To empty header location on board, optional usage.

Customer Reviews

Based on 1 review Write a review

We Also Recommend